No shipping required, software license is emailed within 24 hours.
Please note software is not eligible for returns or cancellation once purchased.
Ask us about compatibility & system requirements before purchasing.
Designed for Mixing Drums
AVA Drum Flow is the next-in-line for Harrison's 'Flow' series plug-ins; an all-in-one processing suite designed for mixing drums...
AVA Drum Flow is a channel strip plug-in designed for mixing drums. It contains 6 routable processing elements and a master section with input, output, and routing controls.
Features
Drum Character
The Drum Character is an EQ that detects the transients of drum hits and allows you to EQ their Attack and Tail ranges separately.
Expander/Gate
The Expander/Gate is a dynamics processor that attenuates signals below a set threshold. This is useful for removing unwanted parts of a signal that were picked up due to microphone bleed.
Signal Generator
The Signal Generator offers a convenient way to enhance drum hits with various types of synthesized signals, such as white noise on a snare or a low-frequency sine wave on a kick.
The generated signal is fed through a gate which is keyed off of the main input allowing the signal to be triggered on drum hits. The generated signal can then be blended with the main input signal in parallel using the Wet and Dry faders.
Compressor
The Compressor is based on the Harrison Mixbus channel strip compressor with the addition of Attack and Release controls.
32C Channel EQ
The 32C Channel EQ is modeled after the analog EQ found on the Harrison 32C channel strip. It has four bands with Frequency and Gain controls, optional high & low shelf filters, and an Output Trim control.
Filters
The Filter module contains a Low-Pass Filter (LPF) and a High-Pass Filter (HPF) with variable slopes. Set the corner frequencies of the Filters by adjusting their Frequency knobs or by typing values directly in to the corresponding Frequency control labels.
Module Controls
The processing elements are separated into modules which can each be individually bypassed, soloed, and reset using the following controls on each module’s top bar.
The Solo button bypasses all processing outside of the module being soloed except for master controls (polarity, input and output trim). This allows individual modules to be auditioned exclusively without hearing the effects of any of the other modules.
The In button toggles the enablement of each module. If disabled, a module’s processing is bypassed and its effects will not be heard.
Master Control Section
The master controls consist of the Input, Output and Routing sections at the bottom of the plug-in editor. The controls in these sections allow you to invert the input polarity, adjust the input & output trim, and set the routing order between processing elements.
_________________________________________ System Requirements
Protection Type
Serial Number (no Dongle required)
Windows Requirements
Host application compatible with:
AAX Native plugins
VST plugins
VST3 plugins
Windows 7 or higher
OpenGL 3.2 or higher
ProTools: 10.3.5 or newer required, enable the AAX format during installation
Logic: Enable the AU format during installation
Cubase: Enable the VST and/or VST3 format during installation
Most other workstations: Enable the VST format during installation
Mac Requirements
Host application compatible with:
AAX Native plugins
Audio-Unit plugins
VST plugins
VST3 plugins
Mac OSX: 10.9 or newer required
ProTools 11 or higher required, Enable the AAX format during installation
Logic: Enable the AU format during installation
Cubase: Enable the VST and/or VST3 format during installation
Most other workstations: Enable the VST format during installation
